no mercy beat`n x out drill help needed

[Tabster]

I have a no mercy x out ball...before I send it back I`d like to know a couple things..If I lay it out with the hart in the strong spot..it puts the cg in my middle finger (the hart is way right of the pin/cg line) Should I drill it like this or is it stamped wrong...there is a mold dot about an eighth" diameter 6 3/4 from the pin 90 degrees left of the marked hart..the hart has the white dot in it though..anyway, give me some info if ya got it!!

[BigDog]

Can you post a picture?

[Tabster]

I`ll post one tomorrow..i must go bowling now:D

[bigj102006]

I have an x-out beatn' also and on mine the hart and the cg was marked wrong if you have a good driller he will always figure out where this stuff is actually located before drilling it. Hope this helps.

Jason

[TenPinSniper]

How where you or the proshop able to determine that the CG or HART where not marked in the correct spot. To me this is not some justment call that a bowler or proshop can make... just my assumption since most of would not have the tools.

The HART is not a Mass Bias, so the determinator will not determine proper HART placement, it will however determine the Mass Bias, which is ummarked.